34
ENGLISH
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Connect external components
No
Part
1
For
/
/
:
Microphone input jack (Page 18)
2
Output terminals (See the following “Connect external amplifiers via output terminals”.)
3
DAB antenna jack (Page 8, 37)
Connect external amplifiers via output terminals
When connecting an external amplifier to the output terminals of this unit,
securely connect the amplifier ground wire to the car chassis to prevent
damage to the unit.
Model
Output terminals
2-way crossover
3-way crossover
REAR:
Rear output
Tweeter output
FRONT:
Front output
Mid Range output
SW:
Subwoofer output
Woofer output
REAR/SW:
Rear/subwoofer output Woofer output
Installation/Connection
Installing the DAB antenna
Connect the DAB antenna to the DAB antenna jack. (See the left column.)
• DAB antenna is supplied for
/
/
.
For details, see the following pages.
• For
, you need to purchase the DAB antenna separately.
For details, refer to the instruction manual supplied with the DAB antenna.
CAUTION
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver’s view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned
on.
– depending on the direction of the broadcast station with respect to the
vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the supplied
cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G)
before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).
JS_KWD_KDC_BT950DAB_EN_EN00.indd 34
JS_KWD_KDC_BT950DAB_EN_EN00.indd 34
2/6/2020 1:52:13 PM
2/6/2020 1:52:13 PM
