Kenton Modular Solo, Operating Manual

Page: 10 / 25

10
P 34 Key-On resets LFO Wave (default :off)
The following can be selected:
Off
[oFF]
On [ on]
- When on, the LFO waveform is reset to the selected start point whenever a new note is played.
AUX2 output
P 40
AUX 2 controller number (default: 7)
- Sets which MIDI controller will control the auxiliary output. The following can be selected:
Off
[oFF]
Pitch bend [Pbd]
Velocity [VEL]
Aftertouch [AFt]
MIDI controllers 0-119
P 41
AUX 2 minimum value (default: 0)
- Sets the level for the Auxiliary output when the MIDI controller source is at its minimum.
Range
-27 to +100
A value of 10 is approximately 1 volt
– so 100 is approx. 10 volts and –27 is approx.
−
2.7 volts
Note that minimum can be set above maximum so that the controller works backwards.
P 42
AUX 2 maximum value (default: 100)
- Sets the level for the Auxiliary output when the MIDI controller source is at its maximum.
Range
-27 to +100
A value of 10 is approximately 1 volt
– so 100 is approx. 10 volts and –27 is approx.
−
2.7 volts.
Note that minimum can be set above maximum so that the controller works backwards.
P 43
AUX 2 reset value (default: 127)
Range
0 to 127
- Sets the level the Auxiliary output will reset to when the MODULAR SOLO is powered on or when it
receives a controller reset MIDI command or a new setup is loaded from memory. This is equivalent to
a MIDI message of this value being received, so it will be influenced by min and max settings above.
AUX3 output
P 50
AUX 3 controller number (default: Velocity)
- Sets which MIDI controller will control the auxiliary output. The following can be selected:
Off
[oFF]
Pitch bend [Pbd]
Velocity [VEL]
Aftertouch [AFt]
MIDI controllers 0-119
P 51 AUX 3 minimum value (default: 0)
- Sets the level for the Auxiliary output when the MIDI controller source is at its minimum.
Range
0 to +100
A value of 10 is approximately 1 volt
– so 100 is approx. 10 volts.
Note that minimum can be set above maximum so that the controller works backwards.