Product Manuals/Man-1088_Sigma XT_26 Page 11 of 40
4.1 Removing the fascia
Open the control panel lid using the 801 lock key.
Before the fascia can be removed it will be necessary to disconnect the power connector terminal
block on the left hand side of the PCB. This is fitted on pins and can be pulled towards you to
remove it. Do not remove the wires from the terminals.
The fascia of the control panel is held in place by two screws. Undo the two screws and lift the
fascia gently away from the box towards you.
With the fascia removed there is much more room inside the panel for making off and dressing
cables.
When cabling work is complete the fascia can be re-fitted with the two countersunk screws and
the terminal block plugged back onto the pins on the board.
Figure 4. Removing the fascia
