background image

6

Kent

®

 is a registered trademark of Aber Living, Hamilton, NZ.

www.Kent.co.nz

1.  Appliances will be free from defects in 

material and workmanship under normal   
use and service when installed and used 
in accordance with all applicable local 
laws and regulations.

2.  If, during the warranty period, a product    

fails to operate properly due to defects in  
workmanship or materials, Aber will either,  
at its option, repair or replace the product  
without charge to the purchaser.

The following circumstances or events 
are either deemed to be outside the 
scope of the general warranty policy 
as set out above, or will invalidate any 
warranty claim:

• 

Normal customer maintenance, including  
yearly maintenance, routine maintenance,  
lubrication, etc.

• 

Damage caused by the continued use of a 
product after a fault has occurred.

• 

Accident, Act of God, nature or war, theft,  
abuse, misuse, negligence or neglect,  
including improper installation.

• 

Failure to operate or maintain the product 
in accordance with the owner’s manual    
furnished with the product.

• 

Any alterations or modifications, including  
those affecting the product’s performance,  
operation, safety, durability or changes in   
its intended use.

• 

Additional damage to parts or components 
due to consented use occurring after any 
of the above conditions.

• 

Incorrect installation or commissioning.

WARRANTY GUIDELINES

• 

Incorrect electrical installation or fitment 
to an inappropriate supply. Any electrical  
installation (fitting and wiring of new wall  
sockets etc) must be performed by a 
qualified electrician.

• 

The warranty applies only to the goods    
supplied and does not cover any other 
damage incurred.

• 

No agent, representative, dealer or 
employee of Aber or any other person 
has  the authority to increase or alter the 
obligations of Aber under these warranties.

Proper Maintenance and Operation

The original purchaser must exhibit reasonable 
care in the maintenance and operation of the 
product as explained in the maintenance 
section of the owner/operator’s manual. When 
in doubt, the Retailer should be contacted by 
the original purchaser for advice.

WARRANTY CLAIM PROCEDURES

Should a product failure occur then the original 
dealer should be contacted together with proof 
of purchase.

The following will apply to all products from 
date of purchase by the original consumer for 
use in a normal, domestic situation.

Portable Electric Heaters: 2 years from 
date of purchase.

Products used for business purposes will carry 
a 90 day warranty.

For full warranty terms & conditions please 
refer to our website: 

www.kent.co.nz.

Summary of Contents for KPE216-408







Reviews: