• Use this appliance only as described in this
manual.
• Any other use is not recommended by the
manufacturer and may cause fire, electric
shock or injury.
Heater Specifications
Model No.: KPE216-071
Heat Settings: 1000W / 2000W
Rating: 220-240V~, 50Hz
ASSEMBLY INSTRUCTIONS
1. Position the heater carefully upside down.
2. Slide the foot support fully into the grooves
in the base of the heater nearest to the
power cord.
3. Slide the wheel set fully into the grooves at
the other end of the heater.
4. Turn the heater the right way up.
Positioning of the Heater
The heater should only be operated at a
minimum distance of 1 metre from any wall or
other object. Position the air flow in order to
optimize the heating of the room.
OPERATING INSTRUCTIONS
NOTE
: When switched on for the first time
a slight odour may be emitted for a few
minutes. This is harmless and occurs with
most appliances as slight traces of dust
dropped or damaged in any manner –
in order to avoid a hazard. Return to a
qualified electrical person for service or
repair.
• Do not operate the appliance with wet hands.
• Do not connect the appliance to the mains
voltage until completely assembled and
adjusted.
• This appliance is not intended for outdoor use.
• Always operate upright, on a flat surface only.
• CAUTION: This product is NOT suitable to
be used on long pile carpets.
• Unroll the cord before operating. Operating
with a coiled cord may cause overheating
and fire risk.
• The use of an extension cord with this
appliance is not recommended.
• Do not remove the plug from the power
socket until the appliance has been
switched off.
• Always hold the plug when removing it
from the wall, do not pull the cord.
• Always unplug the appliance when it is not
in use.
• Do not allow the cord to come in to contact
with the appliance surface during operation.
• Do not run the cord under carpeting, mats
or rugs etc. Arrange the cord away from
traffic areas so that it will not be tripped over.
• Do not twist, kink or wrap the cord around
the appliance as this may cause the
insulation to weaken and split.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• This appliance is intended for light domestic
use and not for heavy duty commercial or
industrial use.
• The appliance must not be located
immediately below or in front of a socket-
outlet.
• CAUTION: In order to avoid a hazard
due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
• Never remove the cover of the appliance –
in case of a fault contact a qualified
service person.
2
