18
9097698000(1)2008-04
Razor™ Plus D24 - D28 - C28
ENGLISH
INSTRUCTIONS FOR USE
TANK EMPTYING
P100304
An automatic loat shut-off system (36) turns off the vacuum system when the recovery tank (21) is full.
The vacuum system deactivation is signaled by a sudden increase in the vacuum system motor noise frequency, also the loor has
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the loat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (73), then
open the cover (22) and check that the loat inside the grid (36) has gone down to the water level. Then close the
cover (22) and turn on the vacuum system by pressing the switch (73).
When the recovery tank (21) is full, empty it according to the following procedure.
Recovery tank emptying
Lift the brush/pad-holder deck by pressing the switch (71).
Lift the squeegee (25) with the lever (10).
Drive the machine to the appointed disposal area.
Turn off the machine by turning the ignition key (80) to “0”.
Empty the recovery tank by means of the hose (16). Then, rinse the tank with clean water.
Solution tank emptying
Perform steps 1 to 4.
Empty the solution tank with the hose (17). Then, rinse the tank with clean water.
Cylindrical brush debris container emptying (only for cylindrical brush deck)
Turn the ignition key (80) to “I” position.
Lower the cylindrical brush deck by pressing the switch (71).
Turn off the machine by turning the ignition key (80) to “0”.
Lower the cylindrical brush deck and remove the debris container (D, Fig. 3) by pulling it on one side with the handle (E).
Empty and wash the debris container (D), and then install it by engaging it on the retainers.
AFTER USING THE MACHINE
After working, before leaving the machine:
Remove the brushes/pad-holders and the cylindrical brushes as shown in the relevant paragraph.
Empty the tanks (20 and 21) according to the procedure shown in the relevant paragraphs.
Perform the daily maintenance procedures (see the Maintenance chapter).
Store the machine in a clean and dry place, with the brushes/pad-holders and the squeegee lifted or removed.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After using the machine paragraph.
Disconnect the battery connector (12).
FIRST PERIOD OF USE
After the irst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
1.
2.
3.
4.
5.
6.
6.
7.
8.
9.
10.
11.
12.
1.
2.
3.
4.
1.
2.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
