Kensington RH-D11, Instruction Manual

Page: 8 / 12

8
0800 422 274
NZ
Operating Instructions
Location
• The heater is for floor standing use only. Place it in an upright position on
a firm, level, dry and heat-resistant floor surface, taking into considering all
relevant safety information on the previous pages.
• Ensure that there is sufficient distance from the wall, fixtures and other
appliances. The distance must be at least 1m to exclude the risk of fire.
Connection
• Plug the heater into an appropriate electrical outlet and switch on power
to the outlet. Always use a separate socket that has no other appliances
connected at the same time – do not plug it into a power board or socket
adaptor; do not use an extension cord. Also ensure that the socket is easily
accessible so that the cord can readily be disconnected in an emergency.
• To turn on the heater, select a power setting and set the thermostat to your
desired heat level/temperature.
Power settings
0 ....Off Set to 0 to turn off the heater.
I .....Low power (approx. 800W) Only the top quartz tube will be working.
II ....Medium power (approx. 1600W) The top and bottom quartz tubes will be
working.
III ....High power (2400W) All three quartz tubes will be working,
as well as the fan to help distribute the
warm air.
Thermostat control
The thermostat regulates the room temperature to maintain it at the set level.
To heat up a room fast, we recommend you set the thermostat to the MAX
position, and when the room is comfortably warm, slowly turn the knob
anticlockwise until the heater stops working. The heater will now cycle on and
off automatically as the temperature drops and rises.
When turning your heater on for the first time it is normal for the heater to
emit a ‘new heater’ smell, which will quickly pass.
This is no cause for concern. Ensure good ventilation.