4
5
3 On your iPad, tap
Settings
.
4 Open
Bluetooth
and make sure Bluetooth is on.
5 On the Keyboard, press the
Bluetooth Connection Button.
The
Bluetooth Status
Indicator Light
starts blinking for 10 minutes or until connected to a device.
6 The Keyboard now appears on your iPad screen. Tap
Bluetooth 3.0 Keyboard.
7 Your iPad screen displays a passkey. Enter the passkey on the Keyboard, and press Enter
.
8 Your iPad screen shows the Keyboard as Connected. On the Keyboard, the Bluetooth
Status Indicator Light turns off.
9 You can now use your Keyboard to type in any app.
NOTE
: To insure the
K Lock
key works correctly please ensure you do the following:
Home page > Settings > General > Passcode key. Verify “ Require Passcode
” is set to
“ Immediately ”
otherwise a keyboard unlock will not require a passcode. Go back to
previous menu and verify
“Passcode Lock ”
is On.
Note the following about the Bluetooth connection between the keyboard and your iPad:
On/Off Switch
press for 5 seconds or longer
then release (regardless of on or off state).
On/Off Switch
for 1.5 to 5 seconds then release = toggle keyboard power
(on to off, off to on).
automatically.
CTRL + FN + F
” for 3 seconds or more = reset to factory default
mode (clear all previously paired BT devices in memory), ALL LEDs should flash on and
off 3 times and keyboard should turn to off mode.
last paired iPad if present. If iPad is not found after waking from sleep mode within 30
seconds, the device should go back to sleep.
LED Behavior and Explanation
LED Behavior
Explanation
off.
Power
LEDs will turn on and stay
lit for 5 seconds.
Power
LED will turn off.
Bluetooth Connection Button
is pressed,
the Bluetooth
or until connected to an iPad.
LED will
go off.
toggle is shown by the
Caps Lock
LED.
Charge
LED will
turn red and turn off only when charge is completed.
Charge the Battery
Charge your Keyboard Expert before initial use or when the Charging Indicator glows red.
1 Insert the small end of the
Charging Cable
into the
micro USB Charging Connector
on the Keyboard.
2 Insert the other end of the
Charging Cable
into your iPad charger.
3 Plug your iPad charger into a working outlet. The
Charging Indicator Light
glows red.
4 When the Keyboard is fully charged, the
Charging Indicator Light
turns off.
board
board
board
board
Bluetooth
LED will begin to blink for 10 minutes