4
Loading slides
Hold the slide up to the light, with the trademark
side facing away from you. When you look through
the slide, the image should appear the correct way
round, not a mirror image.
Rotate the slide 180 degrees, turning the slide so
that the image is upside down while still looking at
the same side.
With the slide holder laid open, place the slide into
the recessed area in the holder. The slide should
fi t perfectly (maximum thickness 1.3mm – most
cardboard and CS type slides will fi t, but glass and
some plastic slides may be too thick).
Note:
Handle slides with care. Any dust, scratches
or fi ngerprints will show on your saved images.
We highly recommend that you wear cotton gloves
when handling and use Kenair Clean Air Duster to
remove any dust on the slide.
Close the slide holder and press the edges so
that it locks in place.
Hold it in the position shown above, then
insert the slide holder into the slot on the
right side of the fi lm & photo scanner.
