Kenner RC-909, User Manual

Page: 5 / 48

IMPORTANT: write down the correct code on the label under the battery
cover. Thus, if needed, you can find it quickly and simply.
Point the remote towards the
controllable device and check
that the keys of the remote are
working. If some or all of the main
keys are not working, repeat steps
2 ~ 4 and try other codes from
the list until all the main keys are
working properly.
Manually switch on the TV.
As with the 'Code setup from the
code table' method, the device
must be fully switched on, and not
just in standby mode!
B. AUTOMATIC CODE SEARCH
Use automatic code search if you have tried 'Code setup from the code
table', but the device cannot be controlled yet. This function ensures
selection of code from an even wider code list entered in the remote
control memory so that the remote can also be programmed for more
specific models.
a) press the [TV] button – the light
will flicker. Release the button.
b) press the [SET] button and
release it only after the light will
switch on and remain switched on.
Aim the remote control against
the TV set.
c) press the [POWER] button, the
light will switch on and will start
flickering at regular intervals.
From this moment automatic
code search mode will have
switched on. If the light indicator
is in any other state, repeat the
abovementioned operations until
the indicator starts to shine and
flash brightly. Transmission of
switch-off code will begin.
The indicating light is on
- 5 -
3301051