TEMPERATURE ADJUSTMENT
l
The tip temperature can be set
as required by turning the
temperature regulating dial. The
housing is marked with
for orientation purposes
(See fig. 4). You can determine
the ideal setting by trial
soldering a joint, as components
have varying properties. It is not
necessary for the tip to
glow bright red to achieve
satisfactory soldering
temperatures.
SPARE PART REPLACEMENT
CAUTION:
Allow the soldering iron to cool down completely. The gas
switch must be in the "off" position. Remove the tip retaining collar,
the tip retaining tube and the tip as before.
l
Front end burner replacement:
Remove the retaining screw using
a 1.5mm (
1/16
") allen key. Note position of retaining screw relative
to alignment mark on iron. Unscrew the front end burner using, if
necessary, a 13mm (
1/2
") spanner, ensure old insulation is
removed and fit new insulation onto gas jet venturi. Fit new burner
tightening until the retaining screw holes are aligned - inline with
alignment mark. Lock in place by re-engaging the retaining screw.
Do not over-tighten.
l
Gas jet venturi replacement:
Remove front end burner as before.
Remove the gas jet venturi by it pulling it directly out from the
QUALITY GUARANTEE &
WARRANTY
KENNEDY TOOLS carry a one year manufacturers warranty.
KENNEDY TOOLS are designed & manufactured
to the highest standards & specifications.
Assuring the quality and performance required by all
sectors of industry.
KENNEDY TOOLS are fully guaranteed against
faulty materials & workmanship.
Should they be found to be defective, they will either be
repaired or replaced free of charge
(fair wear and tear and/or misuse excepted).
This does not affect your legal rights.
Please retain supplier invoice as proof of purchase.
KENNEDY TOOLS
Wigston Works, Leicester, England, LE18 2FS.
www.kennedy-tools.co.uk
Kennedy is a registered trade mark of The Kennedy Group Ltd.
Supplied by an ISO9001 approved company
AVAILABLE FROM YOUR DISTRIBUTOR
TSF524
2.4mm Single Flat
KEN-516-9340K
TDF510
1.0mm Double Flat
KEN-516-9350K
*TDF524
2.4mm Double Flat
KEN-516-9360K
TDF532
3.2mm Double Flat
KEN-516-9370K
*TDF548
4.8mm Double Flat
KEN-516-9380K
*TAB500
Hot Air Blower
KEN-516-9390K
*TAD500
Hot Air Deflector
KEN-516-9400K
*THK500
Hot Knife
KEN-516-9410K
Fig. 4
soldering iron. Replace with new gas jet venturi, aligning its flats
with the corresponding flat in the bore of the iron. Fit new
insulation onto gas jet venturi ensuring, where applicable, that old
insulation is removed from front end burner before replacing.
Replace the front end burner as before (See fig. 5).
SAFETY STAND
l
Always use the integral stand to rest the iron on (See fig. 6).
ACCESSORIES
l
Tips are available as accessories from your local distributor
(See fig. 7).
OTHER QUALITY KENNEDY PRODUCTS
AVAILABLE FROM YOUR DISTRIBUTOR
Fig. 7
Fig. 6
Fig. 5
Gas jet venturi
Front end
burner
Tip
Tip retaining tube
Soldering iron
Insulation
Tip retaining
collar
* denotes tips included in this set.
KEN-516-9320K_Instructions_KEN-516-9320K_Instructions.qxd 19/11/2012 10:16 Page 2