15
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay. After adding items, firmly close the door until it latches and
press START/RESUME, or the delay will not continue.
To delay the start
1.
Press the delay button to choose the number of hours
delayed.
2.
Select a wash cycle and options.
3.
Press START/RESUME.
The dishwasher starts the cycle in the selected number of hours.
NOTES:
■
To cancel the delay and cycle, press CANCEL/DRAIN.
■
To cancel the delay and start the cycle, press START/
RESUME.
Cycle Status Indicators
(on some models)
Follow the progress of your dishwasher with the Cycle Status
indicators.
NOTE:
The features on your dishwasher may vary from those
shown here.
Clean Light
The Clean light glows when a cycle is finished. The light turns off
when you press any button or close the door.
Sanitized Ligt (on some models)
If you select the Sani Rinse option, sanitized light glows when the
Sani Rinse cycle is finished. If your dishwasher did not properly
sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted or the incoming water
temperature is too low. The light turns off when you press any
button or close the door.
Drying System
During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT:
The vapor is hot. Do not touch the vent
during drying.
Overfill Protection Float
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.
