6
7
OPERATION
OPERATION
seating ring
ATTACHING MIXING ACCESSORIES
(See Fig. 5)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Align slot at the top of accessory with pin on Tilt Head
shaft. Push accessory up onto shaft and turn counter-
clockwise until pin moves all the way into the slot.
REMOVING MIXING ACCESSORIES
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Turn Accessory clockwise on shaft until pin on shaft
lines up with slot on accessory. Pull accessory off shaft.
ATTACHING 360° SPLASH GUARD
(See Fig. 4)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Push the splash guard up to fit onto the seating
ring on the underside of the Tilt Head.
REMOVING 360° SPLASH GUARD
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Pull off the splash guard.
WARNING
Never turn on Mixer with accessories attached unless the Bowl is in place.
NOTE
As an optional attachment method, lay the splash
guard on top of the bowl and lower the Tilt Head
onto it.
SPEED CONTROL DIAL
(See Fig. 6)
- The Speed Control Dial is located on the right side of the
Mixer, and is scaled in digits from 0 to 10 (0 equals OFF).
- To start the Mixer, turn the Speed Control Dial clockwise
from 0.
- When using the Splash Guard, you may immediately turn
the dial to the optimum speed of your recipe.
- If not using the Splash Guard, start the mixer on the slowest
possible speed andgradually raise to optimum speed to avoid
splashing ingredients out of the bowl.
OPERATION SAFETY FEATURES
- If the mixer is plugged into an outlet when the speed dial is turned to a speed setting, the mixer
will not start and the work light will flash. Unplug the cord and turn the speed dial to 0 before
plugging it back in.
- If you attempt to lift the tilt head while the mixer is running, the mixer will shut off and the work
light will go out. When you lower the head back into place, the work light will flash. Turn speed
dial to 0 and then to a speed setting to restart mixer.
- If the mixer motor becomes overheated, the mixer will shut off and the work light will flash. Turn
the speed dial to 0 and allow mixer motor to cool down before restarting.
speed digit
CAUTION
When you are finished mixing, turn the speed dial to 0 and unplug
Mixer from the electrical outlet to prevent accidental starting.
CAUTION
Do not scrape the bowl while the Mixer is operating.
The bowl and beater are designed to provide thorough mixing without
frequent scraping. Scraping the bowl once or twice during mixing is
usually sufficient. Turn the Mixer off (Speed Dial to 0) before scraping.
