4
5
PREPARATION
OPERATION
OPERATION
WARNING
To avoid serious injury, keep fingers and hands away
from hinge area when raising or lowering Tilt Head.
BEFORE FIRST USE
• Remove packing material, plastic, labels, stickers or tags that are attached to the mixer, bowl or
accessories.
• Hand wash the Glass Bowl, Bowl Lid, Bowl Clamping Plate, Splash Guard, Easy Pour Funnel Insert,
Flat Beater, Wire Whisk, Dough Hook, Egg Separator and Grater in warm, sudsy water. Thoroughly
rinse and dry all items.
• Clean the outside of the Stand Mixer only with a soft damp cloth, then use dry soft cloth to wipe
dry.
• Rest the Mixer on a level and stable dry countertop or table surface. Also, be sure that the Mixer
is at a safe distance from the surface edge to prevent it from falling off. There must also be enough
room around the back of the Mixer for sufficient air flow through the Mixer motor air vents.
TILT HEAD
(See Fig. 1)
• To attach and remove accessories and bowl you must tilt back the Mixer Head by means of the
release lever on the right side of the mixer (with the front facing you).
• To unlock the Head from operation position, press lever down with one hand, then with other
hand guide spring loaded Head up to lock into raised position.
• To unlock Head from raised position, press lever down with one hand and push Head down until
it locks into operation position.
TILT AND GLIDE
Glides are built into the bottom of the Mixer to allow easy movement from one location to anoth-
er across the same surface. To use, first lower Tilt Head into locked position. With one hand lift up
on Tilt Head Lift Handle to tilt Mixer back onto glides. With other hand grasp Mixer base at front
and push to new location. Lower Mixer back into operation position.
WORK LIGHT
The work light is an LED that shines continuously during mixer operation to help illuminate mixer
bowl contents. It also flashes to alert you of operational errors or motor overheating. See Opera-
tion Safety Features section.
CAUTION : NEVER submerge the Mixer in water. It will be permanently
damaged. NEVER use abrasive cleaning agents or scouring pads to clean
mixer surfaces. They will be permanently scratched.
CORD STORAGE
The power cord is stored in the base of the mixer. Grasp cord
by plug and raise out of slot. Carefully pull the cord out of the
mixer and secure it by pressing it down into the slot.
- The cord is 3-1/2 feet long. Be careful not to overextend the
cord.
- Push the cord all the way back into the base when finished
using mixer.
EASY POUR FUNNEL
The Easy Pour Funnel allows you to add ingredients directly into the mixing bowl from the top of
the mixer.
cord storage
WARNING
To prevent injury to persons or product damage, NEVER pour boiling water
into the glass mixer bowl or use the bowl for heating or cooking purposes.
Extreme temperatures can cause the glass bowl to break or shatter.
ATTACHING BOWL TO MIXER
(See Fig. 2)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Place bowl in Bowl Clamping Plate.
5. Turn bowl clockwise until snug.
REMOVING BOWL FROM MIXER
(See Fig. 3)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Turn bowl counterclockwise until loosened and pull up and out of Bowl Clamping Plate.
tilt head
release lever
