24
Changing the Filter
Locating the Filters
Your refrigerator is equipped with water filtering system.
The water filter system filters all dispensed drinking water,
as well as the water used to produce ice.
Water Filter
The water filter is located at the top right side of the fresh
food compartment.
Ordering Replacement Filters
To order your replacement filters, please visit the dealer
where you purchased your refrigerator. Sears recommends
that you order extra filters when you first install your
refrigerator, and that you replace your filters at least once
every six months.
Here is the product number to request when ordering:
Kenmorepure!
TM
Water Filter
Part #
9919
Replacing the Water Filter
In general, you should change the water filter every
six months to ensure the highest possible water quality.
Water Filter Status
on the user interface prompts you to
replace the filter after a standard amount of water (200
gallons/757 liters for
Kenmorepure!
TM
) has flowed through
the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system. Systems certified for cyst reduction may be
used on disinfected waters that may contain filterable cysts.
Test & Certification Results:
• Rated Capacity - 200 gallons/757 liters for
Kenmorepure!
TM
ice and water filter
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
To Replace your Kenmorepure!
TM
Water Filter:
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/face of the filter.
3. Slide the old water filter cartridge straight out of the
housing and discard it.
4. Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter housing
until it stops against the snap-in connector at the back
of the housing.
5. Push firmly until the cartridge snaps into place (you
should hear a click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the water dispenser while
checking for any leaks at the filter housing. Any spurts
and sputters that occur as the system purges air out of
the dispenser system are normal.
7. After filling one glass of water, continue flushing the
system for about four minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button on the Ice &
Water Dispenser control panel for three seconds. When
the display changes from Red to Green, the status has
been reset.
The
Kenmorepure!
TM
ice and water filter system
is tested and certified to NSF/ANSI Standards
42 and 53 for the reduction of claims specified
on the performance data sheet.
More about your Advanced Water Filter
NOTE
When ordering your replacement filter, please reorder
the same filter type that is currently in your refrigerator.
