10
NOTE
If after adjusting doors higher the door makes a popping/
clicking sound, remove screw and replace with the longer
one supplied in the handle package (select models).
Adjusting Flipper Mullion Screw
To adjust the flipper mullion:
1. Loosen the screw located on the flipper mullion hinge.
2. Adjust flipper mullion height. For proper connection with
the flipper mullion guide, there should be a separation
about the thickness of a coin (0.060 inches, or 1.5 mm)
between the guide and flipper mullion.
3. Retighten screw.
4. Lift the door while adjusting the washer. To raise the
door, rotate washer clockwise (when viewed from the
bottom). To lower door, rotate washer counterclockwise
(when viewed from the bottom).
5. Retighten the screw (where applicable), ensuring it is
between the spokes of the washer. Screw will not be
tight, just insert until it is flush with the hinge.
Adjusting Flipper Mullion Height
Raising/Lowering Door
Screw (where applicable)
Installation (Continued)
