26
27
TROUBLESHOOTING GUIDE
BEFORE CALLING FOR SERVICE (CONT.)
Water temperature control problem.
(Heater Control problem)
Call for service.
Your Washer has tried to fill but has not reached
the proper water level.
Call for service.
The door will not unlock.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer, then turn it on
again. If the code reappears, call for service.
Your washer is not draining.
It can also mean that the unit senses a small
clog while draining.
Before calling for service, check the following.
1.
Turn off the unit and turn it on again.
2.
Select only the Spin Cycle.
3.
Press the Start/Pause to drain the water.
4.
Clean the debris filter.
If it still does not drain, call for service.
Your Washer has tried to fill but was
unsuccessful.
Make sure the water faucets are open all the way. Check for
kinked hoses.
Check the inlet screens on the fill hoses.
Check if the hot water supply hose is
connected.
You must connect the hot water supply hose because hot water
is supplied by the Auto Temperature Control (A.T.C.) function if
the temperature of the cold water is lower than 59°F.
The hot/cold water hose connection is not
correct.
Please connect the hot/cold water hose connection correctly.
Electric service was lost when Washer was
running.
Restart the cycle by pressing the Start/Pause Button.
A fault is detected in the water level sensor.
Call for service
Jammed Key.
Call for service
Motor speed sensor problem.
Restart the cycle.
If the code reappears, call for service.
Temperature sensor problem.
Restart the cycle.
If the code reappears, call for service.
High current detected.
Restart the cycle.
If the code reappears, call for service.
Motor not running properly.
High/Low voltage detected.
Restart the cycle.
Call an electrician to check for electrical issues within the home
before calling service.
If the code reappears, call for service.
592-49032-02855B-01_EN_v1.indd 27
2011-07-22 �� 11:42:19
