11
CAUTION: Remove protective plastic
fi
lm covering
fi
lters before installing them.
!
WARNING: Risk of electrical shock. Electrical wiring must be done by quali
fi
ed personnel in accordance
with all applicable codes and standards. Before connecting wires, switch power o
ff
at service panel and
lock service disconnecting means to prevent power from being switched on accidentally.
1. Connect cable using provided
wire connectors
.
Connect BLACK to BLACK, WHITE to WHITE and
GREEN or bare wire under GREEN ground screw.
DO NOT FORGET TO CONNECT THE GROUND.
CONNECT THE WIRING
FINALIZE THE INSTALLATION
1. Reinstall both side panels.
DO NOT FORGET TO PLUG BACK THE LIGHT CONNECTORS!
2. Reinstall bottom panel using 5 screws from Step 3 of “Prepare The Hood’’ Section.
HE0059
3. Reinstall both
fi
lters.
This hood requires 120 V, 50 W, MR16 type, GU10 shielded halogen lamps (included).
CHANGING LIGHT BULBS
Refer to page 12 for ordering information.
HE0076
WARNING: Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk
of personal injury, only install shielded halogen lamps. Also, never install a cool beam, a dichroïc lamp, a
lamp not suitable for use in recessed luminaires or identi
fi
ed for use in enclosed
fi
xtures.
!
1. To remove lamps, gently push upwards and turn
counterclockwise to disengage bulb leads from their
grooves.
2. Install the new lamps by placing the bulb leads into
their grooves in the socket and gently push upwards
and turn clockwise until secure.
HE0077
W
arr
anty
Saf
ety
Cle
aning
Oper
ation
Installation
Ser
vice P
ar
ts
