8
5. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes for gas to clear away, and repeat
the lighting procedure.
6. To light other burners, repeat step 4.
NOTE: If ignitor does not work, follow Match Lighting
instructions.
Match-Lighting
Do not lean over grill while lighting.
1. Open lid during lighting.
2.
Place match into match holder (hanging from side of cart).
Light match, place into the firebox.
3.
Push in and turn right knob to HIGH position. Be sure burner
lights and stays lit.
4.
Light other burners by pushing knob in and turning to HI
position.
Sideburner Match Lighting
1. Open sideburner lid.
Turn on gas at LP cylinder.
2.
Place lit match near burner.
3.
Turn sideburner knob to HI. Be sure burner lights and
stays lit.
Burner Flame Check
•Remove cooking grates and heat diffusers. Light burners,
rotate knobs from HIGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use.
Turning Grill Off
•Turn all knobs to position. Turn LP cylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
•Turn gas off at LP cylinder.
Push the control knob in and
turn the knob to the left to “HI” position."Click" should be
heard and spark seen each time between collector box or
burner and electrode. See
"Troubleshooting"
if no click or
spark
.
Valve Check
•Important: Make sure gas is off at LP cylinder before
checking valves
. Knobs lock in
OFF
position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
LOW
position then turn back
to
OFF
position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only identical
replacement part valve/hose/regulator as specified in the
Parts List of this Use and Care Guide.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
(and should never be painted)
. Apply a strong
solution of detergent and water or use a grill cleaner with
scrub brush on insides of grill lid and bottom. Rinse and allow
to completely air dry.
Do not apply a caustic grill/oven
cleaner to painted
surfaces.
•
Plastic parts:
Wash with warm soapy water and wipe dry.
Turn controls and gas source or tank OFF when
not in use.
If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes, and repeat the lighting
procedure.
If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of
injury.
Summary of Contents for 148.16656011
Page 28: ...28 ...
Page 56: ...56 美 ...
