10
NOTE
A wiring diagram and technical data sheet are located
under the washer top panel, on top of the detergent
dispenser housing.
NOTE
The standpipe inside diameter must be 1-1/4” (3.2 cm)
minimum. There must be an air gap around the drain hose in
the standpipe. A snug hose
fi
t can cause a siphoning action.
type
type
Grounding
Grounding
receptacle
receptacle
wa
wall
ll
Po
Power cord
wer cord
with 3-prong
with 3-prong
gr
grounded plug
ounded plug
Do not, under any circumstances,
Do not, under any circumstances,
cut, remove, or bypass the
cut, remove, or bypass the
grounding prong.
grounding prong.
Connecting drain and electrical
1
Locate the anti-siphon ring shipped with your washer.
Place it over the end of the drain hose and slide it past
the
fi
rst ring of “accordion” ribs.
2
Form a “U” shape on the end of the drain hose with the
hose pointed toward the drain. Place the formed end in
a laundry tub or a standpipe and secure the drain hose
with the cable tie (provided in the enclosure package)
to the standpipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
3
Plug the power cord into a grounded outlet.
4
Turn on the power at a circuit breaker/fuse box.
5
Carefully slide the washer to its
fi
nal position. Recheck
for level and rock corners for stability. Remove and
discard door tape.
6
Read the
Use & Care Guide
provided with the washer. It
contains valuable and helpful information that will save
you time and money.
7
Run the washer through a complete cycle, checking for
water leaks and proper operation.
8
If you have any questions during initial operation, please
review the “Avoid Service Checklist” in your
Use & Care
Guide
before calling for service.
9
Place these instructions in a location near the washer for
future reference.
IMPORTANT
Check to ensure the power is o
ff
at a circuit breaker/fuse
box before plugging the power cord into an outlet.
Installation Instructions
CABLE TIE
ANTI-SIPHON
DISC
SLIDE DISC
TO HERE
Summary of Contents for 137630800
Page 32: ......