11
LEVELING THE WASHER
The tub of your new washer spins at very high
speeds. To minimize vibration, noise, and unwanted
movement, the floor must be a level, solid surface.
NOTE:
Adjust the leveling feet only as far as
necessary to level the washer. Extending the leveling
feet too far can cause the washer to vibrate.
NOTE:
Before installing the washer, make sure that
the floor is clean, dry and free of dust, dirt, water
and oil so the washer feet cannot slide easily. Leveling
feet that move or slide on the floor can contribute to
excess vibration and noise due to poor contact with
the floor.
Position the washer in its final location, taking special
care not to pinch, stain, or crush the water and drain
lines.
How to control the height
• Slightly lift the front of the product and turn the
height adjustment leg. Turn left to increase the
height. Turn right to decrease the height.
Height-adjusting legs
NOTE:
You may need to use a Unit Leveler Foot if
the floor is uneven on the washer back side. Place the
Foot beneath washer rear leg for leveling.
How to check the levelness
• Raise the washer lid to see the bubble level indicator
in the left front corner before the bleach dispenser.
Adjust the height adjustment leg until the air bubble
is located inside the circle, indicating that washer is
level.
Air bubble
Level indicator
Run calibration
For more precise weight detection, run calibration
when installing the washing machine.
To run calibration, do the following:
1.
Make sure the tub is empty before running
calibration.
2.
While holding down 'Energy Saver' and
'Spin Speed' button, press 'Power' button.
3.
"LS" is displayed and calibration proceeds
automatically.
4.
After 2~3 minutes, the calibration is completed as
'End' is displayed.
INSTALLATION INSTRUCTIONS
Kenmore 세탁기 111.2914#(EN).indd 11
2021-05-14 오후 5:56:20