7
10. ATTACHING THE
LIGHT KIT
NOTE:
Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
There are 2 sets of bulb cover
available in your box. The frosted
cover should be used with bubble
style glass.
1. Remove 1 of 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
2. While holding the light kit under the fan
motor assembly, make the 2-pin wire
connections : (Fig. 15)
- Red to white
- Black to black
3. Place the key holes on the light kit over the
2 screws previously loosened from the
mounting ring, turn light kit until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and the one previously removed.
Figure 15
9. ATTACHING THE FAN
BLADES
Step 1. Insert the blade through the slot in the
housing. Align the holes in blade and motor
and secure with the screws and fiber washers.
(Fig. 14)
Step 2. Repeat this procedure for remaining
blades.
CAUTION:
Make sure all screws are
tightened securely.
Figure 14
Screws
Fiber washers
Blade
Slot
Screws
Mounting ring
LED light kit
Wire connectors
