KENCO Multilift® Operation Manual
7
170 State Route 271
Ligonier, PA 15658
1-800-653-6069
Section IV. Setup.
A.
Check the lifter for any signs of damage incurred during shipping.
B.
Record model and serial #of assembly and components.
C.
Check all bolts for snugness.
D.
Attach Multilift® to hoist.
1.
Use as few rigging components (shackles, slings, chain, etc.) as possible.
2.
ALL RIGGING COMPONENTS MUST HAVE A WORKING LOAD
LIMIT THAT IS EQUAL TO OR GREATER THAN THE COMBINED
WEIGHT OF INTENDED LOAD PLUS THE KENLIFT®.
3.
UNDER NO CIRCUMSTANCES SHOULD ANY COMPONENT USED
AS RIGGING TO THE MULTILIFT® BE OF A RATED CAPACITY
LESS THAN THAT OF THE KENLIFT®.
4.
DO NOT RIG UNPROTECTED NYLON SLINGS OR WIRE ROPE
DIRECTLY THROUGH LIFT BAIL.
5.
IF USING EQUIPMENT OTHER THAN A CRANE: USE RIGGING OF
SUFFICIENT LENGTH TO PREVENT CONTACT BETWEEN
MULTILIFT® AND EQUIPMENT.
Section V. Grip Adjustment
CAUTION
:
The procedures that follow are intended as guidelines. They are to be
carried out by qualified mechanics possessing knowledge of general procedures
and practices involved with the maintenance of heavy machinery.
IMPORTANT
: Wear appropriate protective clothing and personal safety
equipment including safety glasses, hard hat, gloves, protective shoes, hearing
protection, and any special equipment called for by the job conditions.
WARNING
: Failure to observe standard safety practices could result in personal
injury. Service personnel and operators must be fully conversant with the
maintenance and operating procedures.
A.
Place
Multilift®
on object to be lifted to determine grip.
1.
Pads should have a minimum of ½’’ and maximum of 3’’ clearance with
object.
!
!
!
