KENCO Kenlift
®
Operation Manual
Section VI.
Maintenance
A.
Daily:
1.
Visually inspect Kenlift
®
for signs of stress and wear.
2.
Check that bolts and nuts are snug.
3.
Ensure free movement of all components.
4.
Ensure that all warning labels are present and readable.
5.
Check that actuator mounting screws are snug and seated.
6.
Lubricate all moving mechanisms with penetrating oil.
7.
LUBRICATE ACTUATOR WITH LIGHT PENETRATING OIL ONLY
(WD40™)
8.
For Pads:
a.
Check that all pad mounting bolts and nuts are tight.
b.Verify freedom of rotation for pad angle.
c.
Ensure that pad material is sound, and not de-laminated from backing plates.
d.Ensure that pad mounting bolt heads are min.3/32” below the surface of the pad.
e.
Ensure pads are clean and free of any foreign material or substance.
B.
Annually*
1.
Remove pivot bolts and washers, coat with grease.
2.
Inspect holes, pins, bolts etc. for wear. See sect VII for criteria.
3.
Remove actuator, clean and lubricate with light penetrating oil – check for signs
of wear, replace if necessary.
*
Frequency depends on usage, environmental conditions, etc.
BACKING
PLATE
PAD
PAD MOUNTING
CHANNEL OR
ANGLE