Kemppi FastMig MR 200, Operating Manual

Page: 10 / 14

EN
2.4 Panel MR 200 and MR 300 Setup parameters
Normal MIG welding Setup -parameters
Name of
parameter
Name on
display
Parameter
values
Factory
setting
Description
Pre Gas Time
PrG 0.0 – 9.9 s 0,0 s Pre gas time in seconds
Post Gas Time
PoG 0.0 – 9.9 s Aut Post gas time in seconds or automatically according to
welding current (Aut)
Creep Start Level
CrE 10 – 170% 50 % Percentage of wire feed speed:
10 % slowed start
100 % = no creep start function
170 % accelerated start
Start Power
StA -9 ... +9 0 Strength of start pulse
Post Current Time
PoC -9 ... +9 0 Post current
Arc Voltage
Ard OFF, on OFF on: Display shows arc voltage
OFF: Display shows pole voltage
Cable Length
CAb std, 5 – 80m std Cable loss is calculated for optimal arc control and for the
Arc Voltage display
Common Setup -parameters for MIG processes
Name of
parameter
Name on
display
Parameter
values
Factory
setting
Description
Device Address
Add 3 or 6 3 Wire feeder bus address
Using features of
PMT Gun
Gun OFF, on on on = PMT gun
OFF = other gun
Gas Guard
Connected
GG no, YES on Implementation of gas guard
LongSystem Mode
LSY OFF, on OFF on: Gives optimum welding characteristics with long
welding cables
Code Entry
Cod ---, Ent --- Entering license codes manually:
1. Adjust right potentiometer to (‘Ent’).
2. Press REMOTE.
3. Set code with right potentiometer.
4. Choose next with left potentiometer.
5. Go back to point 3, until all codes have been set.
6. Approve by pressing REMOTE. (‘Suc cEs’)
Water Cooler
Coo OFF, on on Enables water cooler
Wire Inch Stop
Inc OFF, on on OFF = Stops wire inch in case arc does not ignite
on = Feeds wire as long as the welding gun start switch
is pressed.
Auto Wire Inch
AIn OFF, on on SuperSnake Automatic Wire Inch function. Wire Inch
button runs the filler wire from the wire feeder up to the
SuperSnake.
Demo Licence Time
dEt 3-h, 2-h, **’,
**’’, OFF The remaining time for the WiseDemo licence
(readable value only).
3-h = max. 3 hours left
2-h = max. 2 hours left
**’ = ** minutes left
**’’ = ** seconds left
OFF = Demo period has expired.
FastMig MR 200, MR 300
8