8
25. Raise video system into approximate position and connect all wiring to components. Route video
cable through hole in mounting bracket. Connect wiring and cabling to video system per
instructions included with video system. Make sure lights in video system operate with door jamb
switch.
26. Check function of all components and lights. See operating instructions for video system
operations check. For further assistance, refer to the video system manual for the technical support
phone number listed for your area.
27. Attach O.E. wiring to rear A/C control head. Carefully
snap O.E. trim ring around control head. Insert control
head into opening and press firmly to engage tabs.
28. Secure rear of console to headliner using (2) two #8 x
2 1/2" screws at the rear light.
NOTE:
Make
sure the plywood is centered in the rear light area
before installing screws.
To prevent
warpage of
console or damage to roof of vehicle, do not
overtighten screws.
See Figure 16. Remove and
discard the # 6 x 1/2" screw from the center mounting
location and replace with (1) one # 8 x 2 1/2" screw.
29. Install trim over rear light fixture.
30. Snap “B” pillar panel in place and
secure seat belt bracket using original
fasteners.
IMPORTANT - TORQUE SEAT BELT
BRACKET TO MFG.
SPECIFICATION
.
31. Reinstall handle and door trim to top of
“B” pillar in original position.
32
.
Install door scuff plates in original position.
FIGURE
16
FIGURE
15
