44
EN
KSB-100
A FEW STEPS TO PERFECT PREPARATION
SAFETY NOTICE
Never leave the blender unattended while it is in operation.
Pay close attention when the device is used by or near children.
Never use the motor for more than 1 minute at a time, as this can cause permanent damage to the
device. If the motor stops working, unplug the device and let it cool down for an hour before it is ready for
use again. The stand mixer has an internal thermal switch that switches o
ff
the device if it gets too hot.
The motor base is reset when the device is not connected and the thermal switch cools down.
To reduce the risk of injury, the blade attachment must be properly attached to the cup before it is
connected to the blender base and before the device is operated.
Never run the blender when the container is empty.
Never mix carbonated drinks, the pressure generated by the released gas can cause the container to
burst, which can lead to injuries. Do not fill the blender jug with liquids that are already hot before
blending.
6. If the desired consistency of the food to be mixed has not yet been reached, wait 1 minute and repeat
the mixing process up to 3 times in a row until the correct consistency is achieved.
If more than three 1-minute blends are required, allow the blender base to cool for 2-3 minutes before
starting the next blending process.
7. To stop the blending process, simply turn the container in the other direction (counterclockwise) to
disengage the container from the base and stop applying pressure to the container and wait for the motor
to turn completely Has come to a standstill.
Never remove the containers from the mixer base before the engine has completely stopped. Removing
the container while the engine is still running can damage the blade clutch or engine transmission.
8. Unplug the blender from the mains when it is not in use.
