RCA2600-P Series Installation/Operation Guide
Page 9 of 11
Rev
A
KELLY MANUFACTURING COMPANY
KMC
KMC
Publication No.1401-2
SECTION 4, GENERAL INFORMATION
4.1 Instrument Care
The most easily damaged part of your instrument is the screen. Special care should be taken when cleaning the screen to prevent
scratches and other damage. Avoid touching the screen at all times.
To clean light spots and dust, use a soft, lint free cotton cloth slightly moistened with distilled water.
You may also use cleaners approved for LCD TV’s and laptop computer screens. For harder to clean spots, use a 50/50 solution of
isopropyl alcohol and distilled water. Vinegar may also be used in a 50% solution with water.
Always apply the cleaner to the cloth and not the screen.
-CAUTION-
●
Do Not
use paper towels, facial tissue or napkins. These products are made from recycled paper and
may contain metals and wood chips that will scratch the screen.
●
Do Not
use acetone or cleaners containing ammonia.
By avoiding all screen contact and by using proper cleaning methods, the user will be rewarded with many years of service.
4.2 OPTIONAL SLIP INDICATOR
An optional Slip/Skid Indicator (inclinometer) is available for all versions of the
RCA2600-P
. The instrument can be purchased with
the slip indicator attached or purchased separately and installed by the user (part number 444-0010-01). The addition of an incli-
nometer satisfies the requirements for FAA’s AC 91-75. The slip indicator may be attached before or after the instrument has been
installed in the aircraft.
INSTALLATION
1. Apply power to the instrument to assure that it reads level in pitch and roll.
2. Remove two screws on the face of the instrument.
3. Align Inclinometer with holes and replace screws. Do not tighten.
4. Adjust the Inclinometer until the bubble is centered and tighten screws just enough to secure Inclinometer. Do not
over tighten.
Figure 4.1, Inclinometer Installation
SCREWS
SLIP INDICATOR
DIM
PITCH SYNC
Summary of Contents for RCA 2600-3P
Page 2: ......
