KELLO-BILT 8226B, Owner'S Manual

Page: 26 / 56

26 . Using a single chain attached to the center of the gang bar, lift the gang bar assembly up to the
frame and bolt into place.
27 . Place the rear gang assemblies under the rear of the center frame assembly and install using the
same procedure as in step 26.
28 . Attach wing frame to center section with pins provided.
29 . Place a support under the wing frame.
30
. Install the hydraulic lift cylinder by attaching the clevis end of the cylinder to the frame and then
by moving the transport assembly either up or down, attach the rod end to the transport assembly.
Be sure to remove the plugs from the cylinder port to allow air to escape.
31 . Chain the transport assembly up to the frame and install the hub and tire assemblies.
25