6
ASSEMBLY
1. Prepare the position of the gates on a level surface. Ensure that the ground under the
selected location is level, and preferably hard-packed so that the feet of the gates cannot
sink into the ground. Put all material which is to be used for the installation nearby. Check
that you have all the parts needed for the assembly.
2. Fit the feet on the legs of the gates (6). The feet with two tubes should be placed at the
front where the gate doors will be. Bolt the gates onto the stabilisers. Note that the gates
for the gable are higher than the side gates. Tighten all bolts. Secure the gates in the
ground with tent pegs/anchors. Drill into the ground if necessary, using a thinner drill
bit to avoid bending the pegs. IMPORTANT! Tighten all bolts to ensure that they do not
come undone.
3. Assemble all arches (3). Fit the arches over the gates, then fit the stabilising struts between
the arches: 2 on either side and 2 on top between the sections. Secure the arches with
bolts, and tighten. Fit the gate doors at the front and secure with tubular pipe clamps.
