EN | LED Floodlight Instruction
Attention: Please read the following instructions carefully to ensure that mounting operation will be carried out
in the right way .These instructions should be properly preserved for future reference.
Ⅰ
.Main construction Data
Type:
Rated
Power
:
Supply
Current
Power
factor
protective
shield
Weigh
t
Maximum
projected
area
Dimensions
Remark:
1524223
10W Max.60
mA
>
0.5
98.4*77.4*
4mm
0.469k
g
204.6cm
2
124*59*165m
m
Electric shock
protection class: I
External light
protection class:
IP65
Rated voltage:
220-240V~
50/60Hz
Mounting
height:<3m
Universal for
operating
position.
1524225
30W
Max.130
mA
>
0.9
172.8*132.
8*4mm
0.79kg 439.8cm
2
199*58.5*221
mm
1524227
50W
Max.220
mA
>
0.9
202.4*154.
4*4mm
1.011k
g
562.2cm
2
229*60.5*245.
5mm
Ⅱ
.Safety instructions
1. Before mounting and maintenance please make sure that the electrical supply has been switched off to
avoid electric shock.
2. The lamp must be earthed.
3. The power cord should be VDE-certified H05RN 3x1.0mm
2
or H07RN-F 3x1.0mm
2
waterproof cable.
4.The lamp can be mounted on normally flammable surfaces.
5
.
The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged, the
luminaire shall be destroyed.
Ⅲ
. Assembly
1.Turn off the power. (see Fig 01)
2.Determine the installation location and mark the wall. (see Fig 02.1)
3. Drill holes with an electric drill at the marked locations.(see Fig 02.2)
4. Plugs into wall mounting holes with included plastic expansion.
(
see Fig 02.3)
5. Use the tool to fasten the included screws, flat washers and fixing brackets to the mounting holes.(see Fig
02.4)
6.Tighten the screws on the mounting bracket with a tool.(see Fig 02.5)
7. The plug is connected to the power socket.(see Fig 02.6)
8. Switch on the power for use.(see Fig.03)
Ⅳ
.Operation
1. The lamp is only suitable for mounting on the wall.The installation height must be less than 3m.(see Fig.
03)
2. The lamp can be tilted down 90
0
and upward 90
0
.(see Fig. 03)
3. The sensor can be rotated 75 degrees left and right, 70 degrees forward, and 90 degrees backward.(see
Fig. 04)
4. The product is equipped with motion sensor which the detection angle is 180° and the max detection dist
ance is 12m.(see Fig.05)
5. The infrared detector is equipped with three adjusting knobs.(see Fig.06)
Time adjustment:
Using this controller,you can select any switch-on time between approx.10±5 seconds and 5±1 minutes
after the last motion was detected.Rotating the TIME controlley clockwise decreases the time
period,rotating it counterclockwise increases it.
Daylight adjustment:
The light adjustment determines from what brightness level the sensor will switch on the floodlight
。
The( sun symbol )position indicates that the sensor works by day and at night,in the(moon
symbol)position,the sensor will only work at night.To adjust the sensor,wait until the desired ambient
brightness is reached.Completely rotate the light adjustment controller to the(moon)symbol.Slowly rotate
the controller in the direction of the (sun)symbol until the floodlight is switched on by the motion. The