kelda BubbleSpa 95005000, Manual

Page: 19 / 28

Brightness Bubble Mode
Off Bubbles not visible to the naked eye
Low
1 2 3
Medium 1 2 3
High
1 2 3
Wet Working mode
Bubble effect light settings
Your Kelda Bubble Spa showerhead comes with a selection of light modes to give you a satisfying Bubble experience no
matter what your mood is or the time of day. The light modes can be activated both when the shower is on (Wet Working
mode) or when the shower is off (Dry Demo mode).
User Guide (BubbleSpa Showerhead)
*Visual representation of how bubbles LOOK at different settings. Pressing the button does not change the frequency of bubbles or flow rate of the Bubble Spa shower.
Wet working mode is automatically activated when water flows through the BubbleSpa head. The default light setting is “1
Low” (see table below). The BubbleSpa shower will return to this setting in the event of the power supply being disconnected.
To change your Bubble light setting simply press the illuminated button in the faceplate.
•
The image above shows the cycle of Bubble Modes
•
Pressing and holding the button ( for 1-2seconds) will turn the light off regardless of which Bubble Mode is currently
selected
•
When the water is turned off the Bubble Mode is stored ready for your next shower
•
“Off” is also saved as a setting – if you find the water on but the main LED array isn’t illuminated, it’s likely that the
Bubble Mode was set to off by the last user. Simply press the button to cycle to the next Bubble Mode
19