![background image](http://html.mh-extra.com/html/keithley/sra-01/sra-01_quick-start-manual_661675003.webp)
3
Figure 1
Connecting the SRA-O1 to digital I/O and combined analog/digital I/O boards.
7. Wire external circuits to the screw terminals, using 12-22 AWG wire. For terminal/pin/port correspondence refer to
Table 1, to Figure 2, to your I/O-board manual, and to manuals for accessories used to connect the board to the SRA-01.
WARNING
Exercise extreme caution when a shock hazard is present. Lethal voltage may be present
on cable connector jacks or test fixtures. The American National Standards Institute
(ANSI) states that a shock hazard exists when voltage levels greater than 30V RMS,
42.4V peak, or 60VDC are present. A good safety practice is to expect that hazardous
voltage is present in any unknown circuit before measuring.
Hazardous rated circuits must be provided with external double insulation or reinforced
insulation. Do not place accessible non-hazardous I/O modules next to hazardous I/O
modules. Refer to the isolation diagram, Figure 4, and to the section “Safety
Precautions.”
CAB-1284CC
STA-3108-D1
SRA-01
ADP-5037
C-1800
KPCI-3107 or KPCI-3108
Board
(Digital I/O Connector)
DASCON-1,
PIO-12/24, KPCI-PIO24
or DAS-1600/1200 Board
(At aux. connector of
DAS-1600/1200)
SRA-01
C-1800
SRA-01
KCAB-PIO
KPCMCIA-PIO24
Board
NOTE: KCAB-PIO cable is included
with KPCMCIA-PIO24 board
PIO-96J or
KPCI-PIO96 Board
SRA-01
ADP-5037
C-1800
Any of
these
CAB-1800
CONN-3160-D1
SRA-01
ADP-5037
C-1800
KPCI-3160 Board
Any of
these