Keithley DMM7510, Reference Manual

Page: 941 / 1036

Section 8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
8-328 DMM7510-901-01 Rev. B / May 2015
trigger.timer[N].clear()
This function clears the timer event detector and overrun indicator for the specified trigger timer number.
Type TSP-Link accessible Affected by Where saved Default value
Function Yes
Usage
trigger.timer[ N ].clear()
N Trigger timer number (1 to 4)
Details
This command sets the timer event detector to the undetected state and resets the overrun indicator.
Example
trigger.timer[1].clear() Clears trigger timer 1.
Also see
trigger.timer[N].count (on page 8-328)
trigger.timer[N].count
This attribute sets the number of events to generate each time the timer generates a trigger event or is enabled as
a timer or alarm.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Restore configuration
Instrument reset
Power cycle
Trigger timer
N reset
Configuration script 1
Usage
count = trigger.timer[ N ].count
trigger.timer[ N ].count = count
count
Number of times to repeat the trigger (0 to 1,048,575)
N Trigger timer number (1 to 4)
Details
If
count
is set to a number greater than 1, the timer automatically starts the next trigger timer delay
at the expiration of the previous delay.
Set
count
to zero (0) to cause the timer to generate trigger events indefinitely.
If you use the trigger timer with a trigger model, make sure the count value is the same or more than
any count values expected in the trigger model.