Return to
Card installation
After connecting the input/output cables, perform the following steps, and refer to
to install the card assembly in the Model 7002-HD mainframe in either
the Card 1 or Card 2 location.
WARNING
Turn off power to all instrumentation (including the Model
7002-HD), and disconnect all line cords. Make sure all power
is removed and any stored energy in external circuitry is
discharged.
1. Slide the card edges into the guide rails inside the mainframe.
2. Carefully push the card all the way forward to seat it fully in the connectors.
3. Make sure the captive screws are securely in place.
Card removal
Follow the steps below to remove the card from the mainframe.
WARNING
Turn off power to all instrumentation (including the Model
7002-HD), and disconnect all line cords. Make sure all power
is removed and any stored energy in external circuitry is
discharged.
1. Loosen the captive screws that secure the card.
2. Pull out on the card until it pulls free from the internal connector.
3. Carefully slide the card out of the switching mainframe.
Summary of Contents for 7002-HD
Page 80: ...A Specifications...
Page 82: ...B Status and Error Messages...