7
DOC06950 Rev. A
INSTALLATION / OPERATION & PARTS CATALOG
CleenSweep
®
- Manual (CSM)
2.
The winch must not interfere with the operation of the floor slats, and there should be a 1” [25mm]
minimum clearance between the winch and slats. Ensure all moving parts of the winch and floor have
adequate clearance. Measure 4” [102 mm] up from the top of the floor slats to locate the bottom of the
mounting plate.
A. WELD ATTACHMENT:
Remove the
winch mounting plate from the winch
assembly, center on the front wall and
weld. Then re-attach winch assembly to
mounting plate using the (4) M10 bolts.
B. BOLT ATTACHMENT:
Transfer the winch
mounting plate mounting bolt hole pattern
to the wall and drill (2) 17/32” [13 mm] bolt
clearance holes. Then attach the entire
winch assembly to the trailer wall using
(2) 1/2” grade 8+ [M12 class 10.9+]
locking fasteners (not included).
3.
Front shield modification: It is recommended that the front shield be hinged or fitted with a door/panel to
gain access to the winch after it is installed to facilitate adjustment, inspection and maintenance.
4. An opening must be cut into the front Slope Shield and a UHMW strap guide installed for the strap to
pass through. The opening must be centered along the path of the strap from the winch to the strap roller
assembly.
