Keith McMillen Instruments QuNeo, User Manual

Page: 26 / 45

Q
u
N
eo
e
diTor
26
Q
u
N
eo
“Continuous Pressure”. In default mode, the sensor will send out
a Velocity value related to how hard the sensor was struck, and
a continuous CC# value corresponding to the pressure exerted
on the sensor. Setting a numerical value in the number box will
override the default behavior and output just that value.
The Global Sensitivity dial adjusts the sensitivity of the
sensors. The higher the sensitivity, the easier it is to get
pressure and velocity in the higher value ranges. The lower the
sensitivity, the more difficult (or impossible) it will be to get the
pressure and velocity to the higher value ranges. The Sensitivity
dial is global for all controls of that sensor type. For example,
if you adjust the global sensitivity of one Pad you are adjusting
the sensitivity of all Pads, however it will not affect the sensitivity
of the sliders.
u
p
/d
oWN
b
uTToNs
- led
s
T
ab
The LEDs tab is where you set which MIDI Channel the Up/
Down button LEDs will listen to for Remote LED Control.
This parameter is global for all Up/Down buttons. For more
information see Section 2.6.2 Remote LED Control.
Uncheck the box marked “Local LED Control” to disable Local LED behavior.
e
diTiNG
r
hoMbus
b
uTToN
The Rhombus button is positioned under the Rotaries and above the Vertical Sliders.
r
hoMbus
b
uTToN
- b
asiC
T
ab
If the “Enable Bank Switching” box is checked, this button
acts as a bank control for the Rotaries, Vertical Sliders, Long
Slider or Pad notes. The banks will be indicated by the LEDs of
the button.
For information about how the LEDs indicate the banks, see the
Banks chapter of this manual.
If Bank Switching is disabled, the button can output an
assigned Note or Pressure CC#. To disable a source, set the
number box below 0 to “off” (-1).
Set the MIDI Channel with the “Channel” number box.
Each sensor has a corresponding drop down menu to select
“Normal” or “Toggle” behavior. “Normal” sensors will engage
while pushed (momentary). Sensors set to “Toggle” will
alternate on and off with each push.
To the right of the toggle menu are number boxes for setting
Velocity and Pressure values. By default these boxes are
set to “var” for “Variable Velocity” and “con” for “Continuous
Pressure”. In default mode, the sensor will send out a Velocity
value related to how hard the sensor was struck, and a