Page 10
DOC1049R (22 February 2024 12:07)
www.keit.co.uk
Back to Table of Contents
NOTE
REMARQUE
Keep the dust caps on connectors and fibres when not in use.
Never leave an exposed fibre connector.
Maintenez les bouchons antipoussière installés sur les
connecteurs lorsqu’ils ne sont pas utilisés. Ne laissez jamais un
connecteur exposé.
NOTE
REMARQUE
Protect the fibre from stress and tight bends (< 30mm bend
radius not allowed!). Tight bends cause a stress at the glass
surface and increase the probability of fracture.
Protégez la fibre des contraintes et des courbures serrées (rayon
de courbure < 30 mm interdit !). Les courbures serrées provoquent
une contrainte à la surface du verre et augmentent la probabilité
de fracture.
2.3.1. Cleaning the Souriau fibre-optic connectors
Disconnect the connector plug from the back of the controller by gently turning the locknut
anti-clockwise as shown below. Do not force it. Forcibly turning any other part of the assembly
may break the connector.
Figure 10: Disconnecting Souriau connectors
To clean the female socket, remove the covers from the tip of the cleaning pen and press it
into both female ports until it clicks.
Locknut
