
10
PFP7/REV C/01-08
suitable plug to the 3-pin AC supply lead. The colours of the wires conform to the
internationally recognised standard such that:
BROWN
LIVE
BLUE
NEUTRAL
GREEN/YELLOW
EARTH
IMPORTANT – THE INSTRUMENT MUST BE EARTHED.
The green/yellow wire in the AC supply must be connected to a properly grounded
terminal.
If a compressor and/or pen recorder is to be run directly from the instrument then they
should be wired to the plugs provided and connected to the POWER OUT sockets (15a
and 15b).
Press the power switch on the front panel. The digital readout should be illuminated.
3. Fill the centre tube of the drain trap and the connecting silicon rubber tubing to the
mixing chamber with deionised water. Check that no air bubbles are trapped in this tube
and that it flows and runs to waste freely. Ensure that the drain trap is pushed
completely down on its clip.
2.5
Accessories
Always use recommended spares and accessories. Even if an alternative part may appear
obviously suitable there may be some minor variations in specification that could degrade the
performance of the instrument.
Accessory
Part Code
Model 8515 air compressor (220V 50Hz)
535 001
Model 8516 air compressor (110V 60Hz)
535 002
Dilutor 230V
Dilutor 110V
037 001
037 002
Analogue to RS232 Data Logger
037 501
Calcium filter
500 125
Lithium filter
500 126
Barium filter
500 127
Butane regulator
500 178
Propane regulator
500 179
Natural gas regulator
500 180
Water separator (small)
500 176
Water separator (large)
500 177
Dust cover
500 134
Cleaning solution (1 litre)
025 171
Minor spares kit
500 172
Major spares kit
500 173