keilhauer.com
1
2
3
4
AWLA Counter & Bar Height Non- Powered Assembly Instructions
With two assemblers holding up the foot rail so it lines up horizontally to the pilot holes located
below the foot rail, proceed to fasten the 1/4-20 x 3/4” Hex socket button head cap screws (x4)
using the drill , Hex driver or Hex key.
With a minimum of two assemblers, proceed to flip the table and place in its final position.
The
table top can now be completely unwrapped.
AWLA Conference Height Powered Assembly Instructions
1
Place table top upside down on a clean surface. One leg has a hollow leg for cable management.
Ensure this leg is fastened to the corner with the protruding power cable
(See Figure a). Proceed to
fasten 1/4“ Post & Cap (x2 each per leg) (
See Figure b).
DO NOT COMPLETELY UNWRAP TABLE
TOP UNTIL STEP 6.
a)
b)
2
Feed the power cable up and into the channel leg, then fasten the black cable channel cover with
1/4-20 x 5/8” flat head socket head cap screw (x6).
Proceed to fasten the remaining screws to the pilot holes located above the foot rail, using the
1/4-20 x 3/4” Hex socket button head cap screws (x4) using the drill , Hex driver or Hex key.
Proceed to fully tighten the the screws fastened to the legs in Step 1.
DO NOT COMPLETELY UNWRAP TABLE TOP UNTIL STEP 6.
Place table top upside down on a
clean surface. Proceed to loosely fasten 1/4“ Post & Cap (x2 each per leg) (
See Figure b).
DO NOT COMPLETELY TIGHTEN THESE SCREWS UNTIL AFTER STEP 5.
3