KegLand RAPT KL24334, Instruction Manual

Page: 4 / 7

KL24334 – RAPT Bluetooth Thermometer Instruction Manual
Page
4
of
7 www.KegLand.com.au Last Updated 25/08/2022 17:23 PM
Sleep Mode
The device will enter “Sleep Mode” after 10 minutes of
inactivity. While in sleep mode BLE will be shown on the display
to conserve battery.
While in Sleep Mode the device will still
transmit data via Bluetooth to any bonded devices .
Press the button to wake the device up and show the measured
temperature on the display.
Operation Instructions
1. Install the batteries and temperature probe and remove the black plastic tip on the probe
before use.
2. Power on the device by holding down the button below the display for at least 3 seconds
3. Bond the device with your RAPT Temperature Controller, RAPT Fermentation Chamber
Controller or Gen 4 BrewZilla. Bonding instructions are
shown below .
4. Submerge the temperature probe into the liquid you wish to measure. The temperature
measured by your RAPT Bluetooth thermometer will then automatically transmit to your
bonded device.
5. Set the RAPT Bluetooth Thermometer to be the controlling temperature sensor for your
BrewZilla or RAPT Temperature Controller.