KL24334
–
RAPT Bluetooth Thermometer Instruction Manual
Page
3
of
7
Last Updated 25/08/2022 17:23 PM
ASSEMBLY & INITIAL START UP
Battery Installation
Slid the cover off the cover off the battery compartment and then install the two supplied AAA
batteries ensuring that they are installed in the correct orientation.
Once the batteries have been installed the device should beep and the screen should automatically
power on.
Power ON/OFF
To power the device ON/OFF, hold down the button for at least 3 seconds.
Temperature Probe Installation
Plug the probe into the 3.5mm female jack on the RAPT
Bluetooth Thermometer.
When the temperature probe is plugged into the device the
display will show the temperature measured by the probe.
If three dashes are shown on the display then this means that
the temperature probe may be unplugged or faulty.