Bucket Blaster Instruction Manual
Page
6
of
10
Last Updated 9/09/2020 2:10 PM
Cleaning Kegs and Fermenters
The Bucket Blaster is ideal for cleaning
and
ball lock kegs while you attend to other
tasks.
It is an easy all in one cleaning solution for ball lock kegs allowing the gas and liquid
posts/diptubes to be cleaned or sanitised simultaneously with the main vessel.
The Bucket Blaster can also be used to clean vessels which do not have ball lock posts such
as:
•
•
•
and
•
•
Step 1. Place the pump and stand assembly in the bucket
Step 2. Fill the bucket with water that is colder than 40°C until the pump is fully submerged.
If using a foaming cleaner or sanitiser such as
more water than if using non foaming cleaners and sanitisers such as
NOTE:
refer to the instruction manual of the vessel for the
temperature requirements of the water.
Step 3. Add the suggested dosage of your cleaner or sanitiser to the water.
Step 4. Place the vessel upside down on the stand as shown in the image below and insert
the spray wand and jet into the opening of the vessel
Step 5. If cleaning a ball lock keg then attach the black (liquid) ball lock disconnect to the
OUT post on the keg and attach the grey (gas) ball lock disconnect to the IN post on the keg.
If cleaning a vessel other than a ball lock keg as long as the ball lock disconnects are
connected to the tubing the system shouldn’t leak and all the cleaning/sanitiser solution will
be directed up the spray wand into the vessel.
Step 7. Turn the pump on and allow the bucket blaster to do the rest.
