Bucket Blaster Instruction Manual
Page
5
of
10
Last Updated 9/09/2020 2:10 PM
Setting up a drip loop
It is essential that a drip loop is set up every time the bucket blaster is used this is to prevent
water following the power cord back into the outlet on the wall.
To achieve this simply loop the power cord below the outlet as shown below.
Submersible Pump Operation
Ensure the pump is always fully submerged in water during operation. Running the pump
dry can result in damage to the pump. If using foaming cleaners or sanitisers such as
make sure that there is adequate water to keep the pump fully
submerged during the entire cleaning or sanitising process.
The pump can either be setup in the bucket for portable use or in a sink for easy clean up.
The flow rate of the pump can be quickly adjusted by changing the inlet gap size on the
pump as shown below.
Switching to smaller outlets and tubing can also reduce
flow rate to a certain extent.
