Kegel FLEX 17-5801, Operator'S Manual

Page: 23 / 303

11
When finished, be sure to refill your conditioning cartridges if necessary.
DO NOT OVERTIGHTEN THE CAP FOR THE CARTRIDGE!
!
Filling the Cleaner supply Tank
With separate water and cleaner tanks
1. To fill the Cleaner Supply Tank, the machine should be in the down or operating
position on the lane.
2. Add water to the supply tank located on the left or the 7 pin side. Add water until you
reach ½” (1.3cm) below the top of the tank.
3. Add straight cleaner to the right tank assembly or the 10 pin side tank.
4. Clean up any spills that may have occurred during the filling.
With single cleaner supply tank assembly
1. To fill the Cleaner Supply Tank, the machine should be in the down or operating
position on the lane. Prepare an appropriate mixture of cleaner and water. Open the
splash guard and place a towel beneath the tank. Open the tank cap and place a
towel around the base of the funnel to prevent foam from over-flowing into the
machine.
2. Slowly pour the mixture into the Cleaner Supply Tank using the supplied funnel until
the level in the tank is about 1/2" (1.3 cm) below the top of the tank. This will
prevent an air pocket from forming and blocking the fluid flowing from the funnel.
Replace cap tightly when finished.
NOTE: Always use the funnel supplied with the machine. This funnel has a plastic filter
screen. This screen filters out large debris and trash to prevent this from contaminating the
supply tank and cleaning system.