KegMaster
™
XL User Manual
Page 9 of 18
Keg King is a registered business name of MCH Australia Pty Ltd
Defrosting the KegMaster
™
XL
WARNING
This unit DOES NOT automatically defrost and may require occasional manual defrosting.
DO NOT scrape any ice or frost from the walls or cold plates.
Doing so may damage the unit and void the Warranty!
NOTE: Excessive ice buildup reduces the efficiency of the unit
For tips on how to limit ice and frost buildup please see our Troubleshooting section.
If excess ice or frost has formed on the inside of the KegMaster
™
XL
…
1.
Turn the unit off at the mains power
2.
Wait an hour or more for the ice to melt. This can take up to a couple of days, depending
on how much ice has accumulated.
A hairdryer may be used, to speed up the process, by gently blowing warm air at the ice.
3.
Wipe any liquid or moisture from the internal walls, floors, and ceiling, using an
absorbent cloth or towel
4.
Turn the unit
’s
power back on.
If excess ice is forming too regularly, see our Troubleshooting tips
Calibrating your KegMaster
™
Series XL Kegerator
When to calibrate your KegMaster
™
Series XL Kegerator
If your kegerator is freezing the chill plate on the inside with a thick layer or ice, it is
recommended to set the calibration at -3 and see if the situation improves.
If the KegMaster
™
is not cold enough, it is recommended to set it to +2 and see it the situation
improves.
How to calibrate your KegMaster
™
Series XL Kegerator?
1.
Press and hold both
the “
Cooler
” and “
Warmer
” buttons
for 5 seconds until the
temperature display flashes
S
C
.
2.
Release those buttons and press
the “
°F/°C
” button
.
3.
The display now shows the calibration factor, and you can change it with
the “
Cooler
” and
“
Warmer
” buttons
.
4.
Once it is at the desired value press the
“
°F/°C
”
button again to save it.
