English
5
6.
Voltage Select
– Select your AC voltage
7.
USB
– For uploading new KASA500 DSP firmware
KASA500 DSP firmware available for download at www.kef.com/kasa500
8.
Software Rev.
– For recording software revision with the supplied labels when updating KASA500 DSP firmware.
9.
EQ-AMP
– 8 Dip switches for selecting KASA500 DSP presets (Confirm software revision matches your preset selection).
10. EQ-LINE OUT
– 4 Dip Switches for selecting Line Output DSP presets (Confirm software revision matches your preset
selection).
11. Line Output
– RCA
Line level output to another KASA500 or power amplifier. When using single LFE input at "
Line Input
" (12) from receiver,
connect to CH1 and set "
Stereo / Mono Input
" (15) to Mono.
12. Line Input
– Use for connecting to line level input signal
13. Speaker Inputs
– Use for connecting to speaker level input signal
14. Line Out EQ / Pass through
– Line Out with DSP preset / Direct Bypass
15. Stereo / Mono Input
Stereo maintains stereo signal into DSP.
Mono splits mono input into both DSP or amplifier channels.
16. 2 Channel / Bridge
– Converts the 2 x 250watt into 4 Ohm amplifier into a monaural 500w x 1 into 8Ohm amplifier –
Unless otherwise instructed – Must be left in 2 Channel Position!
17. 12V DC IN
– Input for "12V Trigger" (any polarity).
18. Manual/Music Sense/12V Trigger
– Sets KASA500 Turn on control
Manual
– KASA500 switches on with front panel On/Standby switch
Music Sense
– if On/Standby switch is on, KASA500 switches on with music signal
12V Trigger
– if On/Standby switch is on, KASA500 switches on with 12V trigger.
19. Speaker Outputs
– Connect to subwoofer or speaker
Use Ch 1 / Ch 2 markings for 2 Channel mode, amp is optimised for 4 Ohm speakers.
Use Bridge marking when in bridge mode, amp is optimised for 8 Ohm speakers.
8
6
14
15
16
18
10
7
9
11
12
13
17
19
Continued on Page 26
KASA500 manual_11b_4301-7477+0.indd 5
2014/1/10 15:49:10
