90
Inspect the piston surface for scratches or other damage.
Inspect the primary cup and dust boot for wear or damage.
MASTER CYLINDER REASSEMBLY AND ERMOUNTING
Reassemble and remount the master cylinder in the reverse order of
Removal and disassembly,and also carry out the following steps.
CAUTION:
Wash the master cylinder components with fresh brake fluis before
reassembly. Never use cleaning solvent or gasoline to wash them.
Apply brake fluid to the cylinder bore and all the internals to be inse-
rted into the bore.
Reassemble and remount the master cylinder,
When remounting the master cylinder on the handlebar,first tighten the
clamp bolt for upside.
CAUTION:
Bleed air after remounting the master cylinder.
Summary of Contents for Focus
