10
Section
4mm
1.
2.
1.
Slide a corner bracket into position and place the spacer over it. Hold the spacer so it is flush with the top of
the leg. Use a straight edge to ensure that the spacer is flush with the end of the leg.
2.
Initially tighten gently with the long end of the Allen key. Then remove the spacer and fully tighten with a
further 2-3 half turns using the short end of the Allen key.
IMPORTANT: These steps are essential to ensure the finished bench is rigid. The spacers must be aligned
precisely, and be flush with the ends of the leg. The screws must be tightened fully.
How to fit the brackets
2
All manuals and user guides at all-guides.com
Summary of Contents for SmartFold Bench
