3.6
Assembly
3.6
Stage 4
1.
Now refer to your Evolution Instruction
Manual to fit the cutter onto the bench.
Set the Table in its working position and
use the Height Adjustable feet to get
the table to within 3mm of flat (as
explained in the Evolution Manual).
Instead of using the woodscrews
supplied with the Evolution use the
Allen screws provided with the bench.
The groove that runs down the middle of
the Bench Edge Extrusion has teeth that
match the thread form of the screw.
Make sure the screw is held vertical with
the short end of the Allen key and hold
it vertical for the first few turns.
On the 210 & 310 sizes of Evolution
Bench the Centre Bracket will prevent
the middle Base Bracket fitting into its
measured position, just move the Base
Bracket to one side so to clear the
Centre Bracket.
